Hid entryprox installation manual

2, HID cards or keytags, in any format up to 37 bits, by entering a single keypad command sequence. A Block Delete feature allows for efficient badge administration by deleting a sequential range of cards/keytags from the EntryProx by user location. Customers can select the HID EntryProx Reader with confidence because HID offers a. EntryProx™ User Guide Part No. , Rev C.2 BEGINNING ENTRYPROX INSTALLATION To mount the EntryProx unit, referring to Figure 2 and Figure 3, follow these instructions: 1. Remove the hex screw located at the bottom of the EntryProx unit. 2. Disconnect the backplate of the EntryProx unit from the controller keypad. 3. BEGINNING ENTRYPROX INSTALLATION To mount the EntryProx unit, refer to Figures 2 and 3 and follow these instructions: 1. Remove the hex screw located at the bottom of the EntryProx unit. 2. Disconnect the backplate of the EntryProx unit from the controller keypad. If your installation must comply with the UL Standard.

About the HID Identity ProxPro View the manual for the HID Identity ProxPro here, for free. This manual comes under the category Security access control systems and has been rated by 1 people with an average of a This manual is available in the following languages: English. HID RH Installation Manual Installation manual (8 pages) HID iCLASS SE RB25F Installation Manual Installation manual (34 pages) Burkert HID ENTRYPROX User Manual Operation user's manual (38 pages) HID VertX EVO V Frequently viewed Manuals. Siemens. Printed in the U.S.A. Specifications subject to change without notice. © HID Corporation HID EntryProx™ Stand-Alone Reader Specifications Typical maximum* read range ProxCard® II card up to " ( cm) ISOProx® II card up to " ( cm) DuoProx® II card up to " ( cm) Smart ISOProx® II up to " ( cm).

Printed in the U.S.A. Specifications subject to change without notice. © HID Corporation HID EntryProx™ Stand-Alone Reader Specifications Typical maximum* read range ProxCard® II card up to " ( cm) ISOProx® II card up to " ( cm) DuoProx® II card up to " ( cm) Smart ISOProx® II up to ” ( cm). BEGINNING ENTRYPROX INSTALLATION To mount the EntryProx unit, refer to Figures 2 and 3 and follow these instructions: 1. Remove the hex screw located at the bottom of the EntryProx unit. 2. Disconnect the backplate of the EntryProx unit from the controller keypad. If your installation must comply with the UL Standard. EntryProx User Manual, , Rev. C.4 Installation and Compliance for UL The EntryProx Model CGNU0 complies with the UL Standard for access control units in a standard, wall-mount installation, when installed to the following specifications: • Electric locking mechanisms may only be connected to the NO contacts of the Main.